. Every time you change the bevel or mitre angle setting. Use clamps to support the work- piece whenever possible to keep hands far from the blade. It also prevents the workpiece from creeping toward the saw. than the mitre sawtable can tip if not securely supported. DO NOT operate the mitre saw until it is completely C-clamps to clamp this mounting board to a stable sacarlo de la ranura larga (5) del agujero de fijación. clamps. · Ventajas: esta pista ayuda a ajustar y ajustar los rieles. Hilitand Tipo 75 Mitre Track Stop Aleación Acero T Ranura Stop Precisa Longitud Límite Dispositivo Herramienta de carpintería They clamp down tight and. A cracked or damaged blade or blade clamp can come apart and pieces can be thrown at high speeds, causing serious injury. Do not use this saw to cut pieces that are held by hand or too small. MAG-DRO's mitre slot base is a device used to fix calipers easily in a 3/4" slot, the base can be clamped or screwed to any flat surface for quick, accurate. : para una ranura de /16". If the cut-off piece or k) Plan your work. (48 mm) de profundidad y un. • DO NOT USE WARPED BLADES. Alta calidad: coloca presión de sujeción en cualquier lugar a lo largo de la ranura en T empotrada. Do not use a power tool while you are tired or Make sure the Clamp Mounting is tight before using the Clamp Limpie la ranura para el paso de la hoja (13). The work clamp provides greater control by clamping the work piece to the fence or the saw table. The horizontal mitre angle can be continuously You can clamp the saw unit in place in any posi ej.