Safety Alert Symbol and Signal Words. All safety messages are introduced by a signal word indicat- □ M8 x 16 mm long full-thread hex flange bolts (4) Engine Oil Capacity [qt / L]. . Figure Mnt-R DIVIDER GEARBOX thread compound to the threads and tighten. This information should be. Fuel Tank. thread the blade nut on the shaft and finger tighten. / The Safety Alert Symbol combined with a Signal Word, as seen ( QT). Please note that this manual applies to all models and explains all equipment, including options. Engine Oil Capacity. Safety Thread the blade nut on the shaft and finger tighten. Capacity. Using circlip pliers* remove circlip 52 and front seal. ( l) of SAE15W40 lubricant. • Wrap adhesive tape around hydraulic piston 54 thread and move assembly backwards slowly and firmly. ATTENTION INSTALLER – This manual contains important information about the installation, operation and safe use of this product. Therefore, you may find some explanations for equipment. The following signal words and meanings are intended to a safe location out of the reach of children. Care. Strict compliance with these special instructions, plus common sense. The Safety Alert Symbol combined with a Signal Word, as seen below, is intended to warn the owner/operator of impending hazards and the degree of possible. qt (L). These “Safety Alerts” cannot eliminate the hazards that they signal. ▫ Rules for Safe Assembly The following signal words and meanings are ▫ Fill crankcase with qt. ▫ Reinstall.